Design Parameter Value Nom. Output Speed (rpm) 1500 Max. Input Speed (rpm) 4500 Max. Axial Load on Input (N)* 1050 Max. Axial Load on Output (N)* 1350 Max. Radial Load on Input (N)* 2100 Max. Radial Load on Output (N)* 2700 Efficiency (%) ≥ 98 Unit weight (kg) 11.6 Min. Operating Temperature (°C) - 10 Max. Operating Temperature (°C) + 90 Protection Rating IP65 Noise (dB)** ≤ 76 Ratio Nom. Output Torque (Nm) Max. Acceleration Torque (Nm) Mass Moment of Inertia (kg/cm²) ~ SINGLE STAGE ~ 1:1 150 225.0 7.70 1.5:1 150 225.0 6.74 2:1 150 225.0 6.31 3:1 120 180.0 6.17 4:1 100 150.0 6.13 5:1 85 127.5 6.12 ~ DOUBLE / TRIPLE STAGE ~ PLEASE SEE FLANGED SERIES FOR LARGER REDUCTION RATIOS AT110L = 1 Input, 2 Output AT110L1 = 1 Input, 1 Output (Clockwise / Anti-clockwise) AT110R1 = 1 Input, 1 Output (Clockwise / Clockwise) For more information, see rotation directions on page 66 * Applied at centre of in/output shaft (Length/2). For more information, see pages 68 & 69 ** Based on 1:1 ratio @ 1500 rpm without load Backlash ~ SINGLE STAGE ~ ≤ 6 arcmin Shaft Option Order Code Smooth Shaft S1 Keyed Shaft S2 Other Options Available Order Code Food Grade Grease on request High or Low Temperature Grease on request NOTE: Example gearbox shown with S2 shaft option AT = Stainless steel ATB = Blackened carbon steel Dimensions and ratings of AT & ATB series are identical ALL BEVEL GEARBOXES ARE SUPPLIED LUBRICATED FOR LIFE WITH NYE® NYOGEL 792D SYNTHETIC GREASE AND CONFORM WITH ATEX EQUIPMENT-GROUP II CATEGORY 2 AS STANDARD TEL: 01827 288122 sales@wmh-trans.co.uk FAX: 01827 253390 www.wmh-trans.co.uk 54 AT110L – Shaft Series Spiral Bevel Range – Stainless or Steel 110 110 100 22 k6 15 55 44 88 44 58 8 2 4x M8 x 19 110 15 2 57 108 h7 55 44 95 BCD 88 4x M8 x 19 6x M6 x 10 6 x 6 x 32 h9 KEY M8 x 1.25 x 19 108 h7 108 h7 22 k6 107 g6 44 72 112 4x M8 x 19 D E F C 1 2 3 4 B A 3 2 1 5 4 6 7 8 AT110R1-1 WEIGHT: SHEET 1 OF 1 SCALE:1:1 DWG NO. TITLE: REVISION DO NOT SCALE DRAWING MATERIAL: DATE SIGNATURE NAME DEBUR AND BREAK SHARP EDGES FINISH: UNLESS OTHERWISE SPECIFIED: DIMENSIONS ARE IN MILLIMETERS SURFACE FINISH: TOLERANCES: LINEAR: ANGULAR: Q.A MFG APPV'D CHK'D DRAWN