b'LinearMotion LinearMotionSpecification - LAS1 LAS3 SeriesLinear ActuatorThrust Pulling HoldingSpeed (mm/s) Standard strokeDutyCurrent max. (A)Model max. max. max. Load=Max./Load=0 (mm) : S cycle(N) (N) (N) % 12VDC 24VDC Screw typeACMELAS-1 1200 1200 800 8 12 50 100 150 200 250 10 6 2.5 Weight* 1.27kgLAS-2 600 600 300 16 25 50 100 150 200 250 10 6 3 Protection IP54LAS-1/ -2 CompatibleCompatible with all controllers30 24(12) VDC Motor controller (*Notice the type of connector: Audio/DIN 4pin)2520 Working temp. +5oC~40oCSpeed (mm/s) Current (Amp) Current (Amp)15 LAS-1LAS-21050 Position feedback specifications (Optical Sensor)0 200 400 600 800 1000 1200Load (N) Supply voltage 24VDC 12VDC 5VDCOutput High level 24VDC High level 12VDC TTL24 VDC Motor LAS-1/ -2 Low level 0.2V/40mA PNP* Low level 0.2V/40mA PNP*3.0 PS. Open collector PS. Open collector2.52.0LAS-11.5 LAS-2 * Stroke length 200mm 1.0 * Option: (1) IP650.5 (2) Position feedback0 1: Potentiometer 10k ohm (RL=S+154)0 200 400 600 800 1000 1200Load (N) 2: Optical sensor: PNP (standard), NPN. TTL(3) 36VDC motor**Note: The test results are obtained by using the 24VDC power supply. (4) Back fixture turned 90oLAS-1/ -212 VDC Motor654RL=S+1463 LAS-1 Stroke250LAS-22 RL=S+1961 Stroke>2500 0 200 400 600 800 1000 1200 RL:Retracted lengthLoad (N) S:Stroke length**Note: The test results are obtained by using the 12VDC power supply.MOTOR CABLE4.5(119)MOTOR CABLE LENGTH=1M Ordering Information MOTOR CABLE DIAMETER=5.548 LAS 1 1 200 24 G E 24 3880.5 1982.5 Model number Special models according to 2-8.101the customers requirement18 18.8 0: Without internal limit switches (Ignore this part of the serial 1: Basic model complete number if not available)21.5 with internal limit switches 5 ColorStroke length B: Black 27 G: Gray (Standard) 81261(RL-102) (29)Voltage RL9.431 T: 01827 288122F: 01827 253391 T: 01827 288122F: 01827 253391 LASE: sales@wmh-trans.co.ukwww.wmh-trans.co.uk E: sales@wmh-trans.co.ukwww.wmh-trans.co.uk120 121'